DISPLAY CONFIGURATION
80
2012-2015 Reliable Controls Corporation
OBJECTS DISPLAYED
The object defined in row number one will be displayed on the default screen of the
SMART-Space Controller.
By default, the row one object is configured as the quick-adjust point, displayed and
adjusted automatically if a user presses the or buttons while viewing the default LCD
screen. If the row one object is configured with Display Only in the User Edit column, the
row two object becomes the quick-adjust point, enabled by configuring its User Edit
column as Can Change.
The other rows can be used to configure the display of any of the points resident in the
controller, including BACnet network objects that have been shared to the controller using
the SHARE or SHARE-NET commands (refer to the Programming section of this manual).
Shared objects can be displayed on the SMART-Space Controller screen, but cannot be
adjusted.
DISPLAY CONFIGURATION COMMAND BAR
The command bar along the bottom of the Display Configuration worksheet has five
buttons, as described in Table 11.
TABLE 11: DISPLAY CONFIGURATION COMMAND BAR
Button Description
Mode Used to toggle the Display Configuration worksheet between
Update, Select, and Edit mode.
If the icon is displayed, values on the worksheet are static,
and are not automatically updated with fresh data from the
controller. Any field can be selected for modification.
If the icon is displayed, the value in the selected field can
be modified.
When an end-user switches from mode to mode, the
current values in the worksheet are sent to the controller, and
the worksheet is updated every few seconds with current data
from the controller.
Setup Opens the SMART-Space Controller Setup dialog box
(described later in this section).
Print Opens a standard Microsoft Windows Print dialog box.
Abort Aborts any changes made to the Display Configuration
worksheet while in Edit mode, and reloads the current Display
Configuration from the controller.
Close Closes the worksheet, and prompts the user to send any
changes that have not been sent to the controller.
To Next Page
Loading...
Need help?
General
