10A-144
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine/gearbox assembly: Removal - Refitting
F9Q
10A
a Fit the new seals on:
-the "condenser - expansion valve" connecting pipe
on the condenser side,
-the "compressor - condenser" connecting pipe on
the condenser side.
a Connect:
-the "condenser - expansion valve" connecting pipe
on the condenser,
-the "compressor - condenser" connecting pipe on
the condenser.
a Tighten to torque:
-the "condenser - expansion valve" connecting
pipe bolt on the condenser (8 N.m),
-the "compressor - condenser" connecting pipe
bolt on the condenser (8 N.m).
a Refit the retaining bolt of the "compressor - conden-
ser" pipe.
a Clip on the wiring of the refrigerant circuit pressure
sensor.
a Connect the connector of the refrigerant circuit pres-
sure sensor.
a Refit:
-the bonnet catch (see Bonnet latch: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms),
-the cooling radiator air deflectors,
-the front impact cross member (see Front impact
cross member: Removal - Refitting) (41A, Front
lower structure),
-the audible warning (see Horn: Removal - Refit-
ting) (82B, Horn),
-the front bumper supports (see Front bumper
support: Removal - Refitting) (42A, Front upper
structure),
-the headlights (see Front headlight: Removal -
Refitting) (80B, Headlights),
-a new exhaust bracket seal,
-the exhaust bracket nuts,
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33) ,
-the differential output seals (see Differential out-
put seal: Removal - Refitting) (21A, Manual gear-
box),
- the front left-hand driveshaft (see Front left-hand
wheel driveshaft: Removal - Refitting) (29A, Dri-
veshafts),
- the front right-hand driveshaft (see Front right-
hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts).
a Refill:
- the engine oil (if necessary) (see 10A, Engine and
cylinder block assembly, Engine oil: Draining -
Refilling, page 10A-40) ,
- the cooling circuit (see 19A, Cooling, Cooling cir-
cuit: Draining - Refilling, page 19A-17) ,
- the manual gearbox (see Manual gearbox oil:
Draining - Refilling) (21A, Manual gearbox),
- the refrigerant circuit using a refrigerant charging
station (see Coolant circuit Draining - Refilling)
(62A, Air conditioning).
a Refit:
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-4) ,
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the battery (see Battery : Removal - Refitting)
(80A, Battery),
- the engine undertray,
- the engine cover.
To Next Page
Loading...
