12A-17
FUEL MIXTURE
Throttle valve: Removal - Refitting
K4M
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove the front engine cover.
a Undo:
-the clip (1) on the throttle valve air inlet pipe,
-the clip (2) on the air filter unit air outlet pipe.
a Disconnect the air filter unit air outlet pipe:
-from the air filter unit,
-from the throttle valve.
a Move the air filter unit air outlet pipe (3) to one side.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the union (4) of the fuel vapour absorber
bleed solenoid valve pipe on the throttle valve.
a Disconnect the connector (5) from the throttle valve.
Tightening torquesm
throttle valve bolts 10 N.m
air pipe clip on the
throttle valve
6 N.m
air pipe clip on the air fil-
ter unit
6 N.m
136458
136460
135924
To Next Page
Loading...
