12A-23
FUEL MIXTURE
Inlet manifold: Removal - Refitting
K4M
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
-the engine cover,
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-17) .
a Disconnect:
- all coil connectors (1) ,
- the air temperature sensor connector (2) .
a Unclip the wiring from the inlet manifold coils.
a Move the coil wiring to one side.
a Disconnect the following from the inlet manifold:
- the inlet manifold pressure sensor connector (3) ,
- the oil vapour rebreathing hose (4) .
Tightening torquesm
bolts 1 to 5 of the inlet
manifold
9 N.m
bolts 6 to 8 of the inlet
manifold
12 N.m
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
136482
136548
To Next Page
Loading...
