12A-41
FUEL MIXTURE
Exhaust manifold: Removal - Refitting
K4M
12A
a Screw on the bolts (4) and (5) without tightening.
a Tighten in order and to torque the bolts of the up-
per heat shield12 N. (m).
a Refit the exhaust manifold stay.
a Tighten to torque:
-the exhaust manifold stay bolt (44 N.m),
-the exhaust manifold stay nut44 N (.m).
a Refit:
-a new ring between the exhaust manifold and the
catalytic converter,
-the exhaust bracket bolts,
-the heater matrix hose retaining bracket.
a Torque tighten the retaining bracket bolt of the
heater matrix hoses10 (N.m).
a Clip the hoses onto the retaining bracket of the hea-
ter matrix hoses.
a Connect the upstream oxygen sensor connector.
a Refit:
-the engine undertray,
-the intake distributor (see 12A, Fuel mixture, Inlet
manifold: Removal - Refitting, page 12A-23) .
a Refit the coils (see 17A, Ignition, Coils Removal -
Refitting, page 17A-1) .
a Refit the throttle valve (see 12A, Fuel mixture,
Throttle valve: Removal - Refitting, page 12A-17)
.
a Refit:
- the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment).
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing).
a Refit:
- the centre section of the scoop under the scuttle
panel grille (see Scoop under scuttle panel
grille: Removal - Refitting) (56A, Exterior equip-
ment),
-the centre section of the scuttle panel grille (see
Scuttle panel grille: Removal - Refitting) (56A,
Exterior equipment).
a Refit the engine cover.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
135255
B95 or D95
B95 or D95
J95
To Next Page
Loading...
