12B-19
TURBOCHARGING
Turbocharger: Removal - Refitting
F4R
12B
a Remove the tools (Ms. 583) from the turbocharger
cooling hoses.
a Refit:
-the turbocharger oil pipes (see 12B, Turbochar-
ging, Turbocharger oil pipe: Removal - Refit-
ting, page 12B-22) ,
-the catalytic converter (see 19B, Exhaust, Cataly-
tic converter: Removal - Refitting, page 19B-17)
,
-the bulkhead upper heat shield,
-Refit the catalytic converter strut.
a Tighten to torque:
-the catalytic converter strut bolt (8 N.m),
-the catalytic converter strut nut (44 N.m).
a Refit the relay bearing.
a Torque tighten the relay bearing bolts (44 N.m).
a Refit the lower engine tie-bar support.
a Torque tighten the lower engine tie-bar support
bolts (62 N.m).
a Refit:
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33) ,
-a new right-hand differential output seal (see Diffe-
rential output seal: Removal - Refitting) (21A,
Manual gearbox),
-the front right-hand wheel driveshaft (see Front ri-
ght-hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts).
a Fill the manual gearbox (see Manual gearbox oil:
Draining - Refilling) (21A, Manual gearbox).
a Refit:
-the connecting hose (see 19B, Exhaust, Connec-
ting hose: Removal - Refitting, page 19B-60) ,
-the engine undertray,
-the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
-the lifting eye,
-the turbocharger heat shield.
a Refit:
- the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
- the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
- the windscreen wiper arms (see Rear screen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing).
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.