13B-100
DIESEL INJECTION
High-pressure pipe between the rail and injector: Removal - Refitting
K9K, and 830
13B
III - FINAL OPERATION
a Refit:
-the injector rail protector cover,
-the injection rail protector cover bolt.
a Clip on the injector rail protector cover plate.
a Fit the dipstick guide tube.
a Refit:
-the dipstick guide bolts,
-the dipstick.
a Refit the turbocharger air outlet pipe (see 12B, Tur-
bocharging, Intercooler air inlet pipe: Removal -
Refitting, page 12B-41) .
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.
a Reprime the fuel circuit using the manual priming
pump.
a Check that there are no diesel leaks (see High pres-
sure pipe: Checking) .
To Next Page
Loading...
