13B-122
DIESEL INJECTION
Fuel temperature sensor: Removal - Refitting
K9K, and 834
13B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove the front engine cover.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the fuel temperature sensor connector
(1) .
Tightening torquesm
fuel temperature sensor 15 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 13B, Diesel injection, Diesel injec-
tion: Precautions for repair, page 13B-1) .
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
Note:
Ensure you have a new fuel temperature sensor to
hand before opening up the fuel circuit.
137857
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
To prevent impurities from entering, once the fuel
circuit is opened, it must not be blasted with com-
pressed air. Use cleaning cloths only, if neces-
sary.
To Next Page
Loading...
