13B-123
DIESEL INJECTION
Fuel temperature sensor: Removal - Refitting
K9K, and 834
13B
a Remove the fuel temperature sensor (2) from the
high pressure pump.
REFITTING
I - REFITTING PREPARATION OPERATION
a
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the fuel temperature sensor.
a Torque tighten the fuel temperature sensor (15
N.m).
a Connect the fuel temperature sensor connector.
III - FINAL OPERATION
a Refit the engine cover.
137859
Note:
Do not lubricate the seals with grease or old die-
sel fuel. Use the applicator provided in the kit for
the new part.
To Next Page
Loading...
