13B-143
DIESEL INJECTION
Diesel injector: Removal - Refitting
K9K, and 830
13B
a
a Torque tighten the bolts of the diesel injector
bracket (28 N.m).
III - FINAL OPERATION
a Remove the blanking plug of each diesel injector.
a Refit the high pressure pipe(s) between the injector
rail and the diesel injector(s) (see 13B, Diesel injec-
tion, High-pressure pipe between the rail and in-
jector: Removal - Refitting, page 13B-87) .
a Connect the diesel injector fuel return rail to the die-
sel injector.
a Check that there are no fuel leaks.
a Connect the battery (see Battery : Removal - Refit-
ting) (80A, Battery).
a Refit the engine cover.
a Apply the after repair procedure using the diagnos-
tic tool :
-connect the diagnostic tool,
-select "Injection computer",
-go to repair mode,
-display the "Before/after repair procedure" for the
computer selected,
- select "Injector" in the "List of components stored
by this computer" section,
-carry out the operations described in the "After re-
pair procedure" section.
19724
Note:
If reusing a diesel injector, refit the injector in the
cylinder marked beforehand. If reusing a diesel
injector, note the alphanumeric code (5) of the
injector and the cylinder on which it is fitted.
To Next Page
Loading...
