16A-21
STARTING - CHARGING
Starter: Removal - Refitting
K4M, and 858 or 866
16A
REFITTING
I - REFITTING PREPARATION OPERATION
a Check that the centring dowel is in place.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the starter.
a Torque tighten the starter bolts (44 N.m).
a Fit the starter wiring.
a Tighten to torque:
-the starter supply cable nut (8 N.m),
-the starter excitation cable nut (5 N.m).
III - FINAL OPERATION
a Connect:
-the oil level sensor connector,
-the battery (see Battery: Removal - Refitting)
(80A, Battery).
a Refit the engine undertray.
To Next Page
Loading...
