Renesas PG-FP5 User Manual

PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 143 of 240
Jul 15, 2010
8.4 Description of FP5 Control Commands
This section will describe the FP5 control commands.
8.4.1 autocon command
Selects and confirms automatic or manual execution of the processes, from “transition to flash memory programming
mode” to “signature verification”, and “the termination of the flash memory programming mode”.
Input format
'autocon' ('on | off')
Description of the function
Selects either automatic (on) or manual (off) execution, to be executed before and after the device command
completion, of the processes from “transition to the flash memory programming mode” to “signature verification (con
command)”, and “termination of the flash memory programming mode (dcon command)”. The initial value is automatic
(on). If this command is executed without an option, the current status is displayed (automatic (on) or manual (off)).
The default setting is automatic (on).
on: The con command and dcon command are executed automatically.
off: The con command and dcon command are executed manually. When set to manual (off), the con command is
executed, then the device command can be executed. Furthermore, various device commands can be executed
multiple times. Execute the dcon command to terminate. Note that the ep (epv) command will automatically
execute the con command and dcon command even if this is set to manual (off).
Example of usage
Command Screen output
autocon AutoCon is on / off
autocon on AutoCon is on
autocon off AutoCon is off

Renesas PG-FP5 Specifications

General

Brand	Renesas
Model	PG-FP5
Category	Motherboard
Language	English