PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 166 of 240
Jul 15, 2010
8.4.24 version_up command
Updates the firmware.
Input format
'version_up'
Description of the function
Upgrades the firmware. After this command is executed, the firmware file must be downloaded to the FP5 in ASCII
format using communications software. If using HyperTerminal, select Transfer(T) -> Transfer text file(T)..., and then
select the firmware file. After the firmware version has been updated, the FP5 will be reset.
Example of usage
Refer to the following pages.
To Next Page
Loading...
