Renesas PG-FP5 - C.2 DC Characteristics

PG-FP5 APPENDIX C ELECTRICAL SPECIFICATIONS OF TARGET INTERFACE
R20UT0008EJ0400 Rev. 4.00 Page 219 of 240
Jul 15, 2010
C.2 DC Characteristics (TA = 0 to 40 °C)
(1/2)
Pin name Symbol Parameter or Conditions MIN. TYP. MAX. Unit
Output voltage, high 1.2 5.5 V VDD
V
DD2
V
OH
Output voltage accuracy, high
(I
OH = 100 mA)
Setting
value
Note
−5%
Setting
value
Note
Setting
value
Note
+5%
V
VOL Output voltage, low 0 5.5 V VPP
V
OH Output voltage, high 1.2 12 V
VOL1 Output voltage, low (IOL = 100 μ A) 0 0.2 V
VOL2 Output voltage, low
(V
DD = 3.0 V, IOL = 8 mA)
0.5 0.7 V
VOL3 Output voltage, low
(V
DD = 4.5 V, IOL = 16 mA)
0.9 1.1 V
VOH1 Output voltage, high (IOH = 100 μ A) VDD – 0.2 VDD V
VOH2 Output voltage, high
(V
DD = 3.0V, IOH = 8 mA)
2.1 2.6 V
FLMD0
FLMD1
RESET
SO/TxD
SCK
CLK
V
OH3 Output voltage, high
(V
DD = 4.5V, IOH = 16 mA)
3.1 3.7 V
IIL Input voltage, low VDD×0.30 V SI/RxD
H/S
I
IH Input voltage, high VDD×0.75 V
Note The setting value in the [Vdd[V]] box and [Vdd2[V]] box on the [Advanced] tab of the Device Setup dialog box
(2/2)
Pin name Symbol Parameter or Conditions MIN. TYP. MAX. Unit
IOH1 Output current, high (VDD = 1.2 V) +100 mA
IOH2 Output current, high (VDD = 3.3 V) +300 mA
IOH3 Output current, high (VDD = 5.0 V) +350 mA
VDD
V
DD2
I
IH Input current, high +10 mA
VPP IOH Output current, high +200 mA
IOL Output current, low −16 mA FLMD0
FLMD1
RESET
SO/TxD
SCK
H/S
CLK
I
OH Output current, high +16 mA
ILIL Input leakage current, low −10 μ A SI/RxD
H/S
I
LIH Input leakage current, high +100 μ A
<R>
<R>