PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 175 of 240
Jul 15, 2010
8.5.9 gsc command
Obtains the information of security get for the target device.
Input format
'gsc'
Description of the function
Obtains the information set by executing the [Set Security] command on the [Device] menu of the programming GUI.
Example of usage
Command Status Status LED Message display Screen output
Display after executing the command
[When completed normally]
PASS
Returns to the display
before executing the
command.
[Display example]
Security Flag: xx
Boot Block Number: xx
FS area: xxxx – xxxx
PASS
Security operation finished.
gsc
Display after executing the command
[When terminated abnormally]
ERROR
ERROR: xxx
xxxxxxxxxxxxxxxx
ERROR(Exxx): <text>
To Next Page
Loading...
