PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 160 of 240
Jul 15, 2010
8.4.17 selftest command
Executes a self-test.
Input format
'selftest'
Description of the function
Executes a function similar to the programming GUI [Programmer] menu -> [Self-Test] command.
Example of usage
Command Screen output
selftest ***** CAUTION *****
Remove any plugs from Target- and Remote-Connector before starting.
Any hardware attached to those connectors may be damaged by this
test !
***** CAUTION *****
Target- and Remote-connector unplugged ?
If yes, press 's' to start the test: s
FPGA Test: PASS
Power Supply Test: PASS
Target- and Remote-Interface Test: PASS
Selftest PASSED.
To Next Page
Loading...
