Renesas PG-FP5 - Target Cable

PG-FP5 CHAPTER 9 CONNECTORS AND CABLES
R20UT0008EJ0400 Rev. 4.00 Page 188 of 240
Jul 15, 2010
9.4.1 Target Cable
The target cable is a standard shielded cable approximately 42 centimeters long. The target cable is equipped with a
15-pin HD-SUB male connector and a 16-pin 2.54 mm pitch multipurpose female connector.
Figure 9-10. Target Cable Outline
15-pin HD-SUB male connector
Figure 9-11. 15-Pin HD-SUB Male Connector Pin Assignment
1
5
6
11
10
15
Figure 9-12. 16-Pin 2.54 mm Pitch Multipurpose Female Connector Outline (View from Socket Side)
1 3 5 7 9 11 13 15
2 4 6 8 10121416
Table 9-3. Target Connector Pin Configuration
Signal Name 15-Pin HD-SUB Male Connector
16-Pin 2.54 mm Pitch Multipurpose
Female Connector
GND 15 1
RESET 4 2
SI/RxD 2 3
VDD
Note 3
8 4
SO/TxD 1 5
VPP 11 6
SCK 3 7
H/S 7 8
CLK 14 9
VDE
Note 1
13 10
VDD2 5 11
FLMD1 6 12
RFU-1
Note 1
10 13
FLMD0 12 14
Not used
Note 2
−
15
Not used
Note 2
−
16
Notes 1. Reserved pins. Leave these pins open.
2. Left open in the target cable.
3. No.9 pin of 15-pin HD-SUB connector is not connected to a 16-pin 2.54 mm pitch multipurpose connector.
16-pin 2.54 mm pitch multipurpose female connector