Renesas PG-FP5 - Page 147

PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 147 of 240
Jul 15, 2010
(2/2)
Command Screen output
conf See below.
Firmware Version Vx.xx
Board H/W Vx, FPGA Vx
Serial No.: xxxxxxxxxx
Standard mode unsecured
Number of Program areas: 4 Active Program Area: 0
Size of Program Areas (Code / Data):
Area 0: 0x400000 / 0x020000
Area 1: 0x400000 / 0x020000
Area 2: 0x400000 / 0x020000
Area 3: 0x400000 / 0x020000
Area Filename Date Time Range CRC
*0 sample.hex 2006-02-24 21:13 000000-007FFF 61D5F67C
1 {unknown data}
2 {unknown data}
3 {unknown data}
Checking Progareas.........
No invalid data found.
Area Parameter file PR5 CRC ESF CRC
*0 78F1166 C8005840 D0401B9D
1 {invalid}
2 {invalid}
3 {invalid}
AutoCon is off
Sound is on
AutoPowerOff is disabled
Security state is: Inactive
Authorization procedure is: Undefined
Manager option byte: 0x00
HEX file Upload enabled
Device Setup enabled
Checksum comparison off
Reset option Hi-z