Renesas PG-FP5 - Page 207

PG-FP5 APPENDIX A MESSAGES
R20UT0008EJ0400 Rev. 4.00 Page 207 of 240
Jul 15, 2010
(3/4)
No. Message Description
E 1516 Error line : <line number>
Data error. Abort DATA Check
An illegal data exists in line line-number in the program file.
E 1517 Shortage of memory. Confirm that sufficient memory capacity is available in
Windows.
E 1518 Invalid file name. The file name is invalid.
E 1519 HEX format error. An illegal program file format was detected.
E 1520 Too large address. The address is too large. The maximum address that can
be used by the HEX Editor is 420000h.
E 1521 Can not run <command name> Running of the command-name command has failed.
E 1522 Illegal address The range of the data storage address is invalid. The start
address may be larger than the end address.
E 1523 <file name> could not be opened. Abort Save File <file-name> cannot be opened. File saving was aborted.
E 1524 Data error. Abort DATA Check A data error has been found in the program file. Data
checking was aborted.
E 1525 Temporary file could not be read. Abort Save File Opening of the temporary file has failed. The file may be
corrupted.
E 1526 Error line : <line number>
Data Count error. Abort "Data Count Check"
A data count error has occurred in line line-number. The
program file format may be incorrect.
E 1527 Cannot open temporary file. Opening of the temporary file has failed. The file may be
corrupted.
E 1528 File Save error. Abort "Save File" Saving the file has failed.
E 1529 <line number> Check sum error. Continue ? A checksum error has occurred in line line-number. The
program file format may be incorrect. Select whether to
continue the operation.
E 1530 Too large address. Edit range: 0 - 0x420000 The program file address is too large. Set an address value
in the range 0 to 420000h.
E 1531 Data Flash format error: <data address>: Invalid ID Tag. The data flash format is invalid. Valid 4 bytes are followed
by an ID tag of 4-byte FFh or 4-byte 00h in the data flash
area. An error occurs if the ID tag includes defects, or FFh
or 00h is included.
E 1532 Parameter of "Start Address" is invalid. The value input as the start address is not a valid
hexadecimal number.
E 1533 Parameter of "End Address" is invalid. The value input as the end address is not a valid
hexadecimal number.
E 1534 Temporary file could not be read. Abort Dump Hex The temporary file cannot be read. Opening of the HEX
Editor was aborted.
E 1535 Can not open <file name> Abort 'Dump Hex' <file-name> cannot be opened. Opening of the HEX
Editor was aborted.