Renesas PG-FP5 - Page 236

C-4
(4/5)
Edition Description Applied to
A.2 Error/Warning Dialog Boxes for Programming GUI Operation
A.3 Information Dialog Boxes for Programming GUI Operation
A.4 Error Messages Displayed in FP5 Message Display
• Addition of messages
APPENDIX A
MESSAGES
3rd
edition
C.2 DC Characteristics (T
A = 0 to 40°C)
• Change of V
OL and ILIL
• Addition of ILIH
APPENDIX C
ELECTRICAL
SPECIFICATIONS OF
TARGET INTERFACE
Change of the URL of "Version-up Service" Throughout
1.6 Hardware Specifications
• Change of Table 1-1. Hardware Specifications
CHAPTER 1
OVERVIEW
4.3.1 [File] menu (2) [Upload from FP5...] command
• Addition of Figure 4-9. [Upload from FP5...] Dialog Box in the HEX Editor (b) The
uploaded file is for a target device that supports data flash
Figure 4-37 Action Log Window
• Change of the title
4.3.3 [Device] menu
• Change of the following figures
Figure 4-45. [Get Flash options] Command
Figure 4-64. Device Setup Dialog Box - [Advanced] Tab
Figure 4-68. [Flash options] Area
Figure 4-70. [Security flag settings] Area
4.3.3 [Device] menu (14) [Setup] command (c) <5> [Security flag settings] area
• Addition of Disable FSW re-setting
CHAPTER 4
PROGRAMMING GUI
USAGE
CHAPTER 5 EXAMPLE OF OPERATION USING PROGRAMMING GUI
• Change of Figure 5-15. Device Setup Dialog Box - [Advanced] Tab
CHAPTER 5
EXAMPLE OF
OPERATION USING
PROGRAMMING GUI
6.3.3 [Option Setting] menu
• Change of Table 6-3. [Option Setting] Menu
CHAPTER 6 USAGE
IN STANDALONE
MODE
8.1 Starting the Communications Software (3) Start HyperTerminal
• Addition of the Caution
CHAPTER 8
USAGE
COMMUNICATION
COMMANDS
9.1 Power Supply Connector
• Change of the Caution
CHAPTER 9
CONNECTORS AND
CABLES
CHAPTER 10 NOTES ON TARGET SYSTEM DESIGN
• Change of Figure 10-6. Circuit Example for V850 (Single-wire UART)
CHAPTER 10
NOTES ON TARGET
SYSTEM DESIGN
4th
edition
A.4 Error Messages Displayed in FP5 Message Display
• Change of No.091 (IVerify failed)
APPENDIX A
MESSAGES