PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 55 of 240
Jul 15, 2010
(2) [Logging] command
The [Log
ging] command saves information displayed in the action log window in the log file. When this command
is executed, the log file save dialog box appears. Move to an arbitrary folder, select the log file in the [File n
ame]
drop-down list, and click the Save button; the log file will then be saved. The [Logging] command on the menu
bar will be checked. The check mark will be cleared by clicking the [Logging] command again and saving of the log
file will be stopped. Enabling/disabling the [Log
ging] command is added to the time stamp. For a log file example,
refer to Figure B-3 Log File Example.
Remark The log file that was saved the last time is displayed in the log file save dialog box.
Figure 4-15. Log File Save Dialog Box
Clicking the S
ave button saves the specified log file.
Clicking the Cancel button closes the dialog box without saving the log file.
To Next Page
Loading...
Need help?
General
