Research Instruments INTEGRA 3 - Page 51

Syringes

Research Instruments Ltd
9
Secon 9
Figure 9-11
Figure 9-12
Figure 9-13
Plunger Tip
4. Turn the SOS to a horizontal posion. Add a few drops of oil to the ll
port unl the oil is level with the top of the port.
5. Ret the cap ensuring that no air bubbles are trapped underneath.
A small amount of oil may be spilled, which should be wiped away
with an absorbent paper towel.
6. With each procedure the operang posion of the plunger will move
further towards the p of the SOS. When the plunger is close to the
p as shown, the system should be topped up with oil.