Ricoh 150 - Page 149

When You Cannot Use the Machine As You Want
147
8
Problem
Possible cause
Solutions
There is no battery power
remaining.
Connect this machine to a device
that supports the USB PD
standard or to a USB PD charger
to charge the battery.
Screen does not
switch
automatically
The condition that the input
method switches
automatically is not met.
For details about the conditions
under which the input method
switches automatically, see page
31 "Switching Inputs".
There is a problem with the
connected device.
Change the device.
USB Type-C cable is
damaged.
Replace the USB Type-C cable.
There is no battery power
remaining.
Connect this machine to a device
that supports the USB PD
standard or to a USB PD charger
to charge the battery.
• A charger that is not
supported by this
machine is used.
• There is a problem with
the USB PD charger.
Replace the USB PD charger.
The screen is dark
(when wired
connection is used).
The brightness of this
machine is set low.
Change the brightness setting in
the On-screen Display menu.
page 114 "Setting Items in the
On-screen Display Menu"
Insufficient power is being
supplied to this machine
from the connected device.
Connect this machine to a USB
PD charger.
The original image is
darkened.
Check the video brightness on
the device side.
The power supply is less
than 15 W output, and the
remaining battery power is
less than 2%.
Connect this machine to a USB
PD charger to charge the battery.