Due to the specifications of
wireless video transmission,
noise can occur when
displaying video with a lot of
movement.
The image is
delayed (when
wired connection is
used).
A high-load process is
running on the device.
The image is
delayed (when
wireless connection
is used).
The network signal condition
is poor.
Check the network status and
reconnect.
A high-load process is
running on the device.
This machine is generating
heat due to charging of the
battery.
Stop charging this machine or
use it after charging is complete.
Wireless connection to the
device and to the access
point is used at the same
time.
Disconnect from the access point
before connecting to the device
via wireless connection. To
disconnect from the access
point, move to a location where
the access point is out of range
or select and delete the network
you want to disconnect from the
"List of Saved Networks" on the
Wi-Fi screen.
The screen
switches
unintentionally.
If there is no video input
signal and nothing is
displayed on the screen, the
input method is
automatically switched
when a video input is
connected to another port.
There is a problem with the
connected device.
USB Type-C cable is
damaged.
Replace the USB Type-C cable.
To Next Page
Loading...
