Ricoh 150 - Page 160

8. Troubleshooting
158
8
Problem
Possible cause
Solutions
• Check that there are no
devices in the surroundings
that generate radio waves
that could interrupt wireless
communication, and then try
the wireless connection
again.
Environment-dependent
characters are used in the
network SSID.
Change the SSID to one that
does not contain environment-
dependent characters.
Does not
automatically
connect to
networks saved in
the "List of Saved
Networks"
The signal from the access
point does not reach this
machine.
Move to a location where the
access point's signal can be
received.
The network signal condition
is poor.
• Check the network status
and reconnect.
• Check that there are no
devices in the surroundings
that generate radio waves
that could interrupt wireless
communication, and then try
the wireless connection
again.
Already connected to the
device
The network cannot
automatically connect to a device
while it is connected to the
network. When the connection to
the device is disconnected, it can
automatically connect to the
network.
Want to erase the
entered network
password
-
Select the network that you want
to delete from the "List of Saved
Networks" on the Wi-Fi screen
and delete it.
page 100 "Wi-Fi"
The device cannot
be registered in the
"Connection list".
Registration to the
Connection list is disabled.
Turn ON "Register to cxn list" on
the Connection list screen.
page 101 "Connection List"