Installing the Board (Optional)
• Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside
this machine are high voltage components that are an electric shock hazard and laser
components that could cause blindness. Contact your sales or service representative if any of the
machine's internal components require maintenance, adjustment, or repair.
• Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
Note again that exposure to the laser components inside this machine risks blindness.
• Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies
and small children at all times. Suffocation can result if polythene materials are brought into
contact with the mouth or nose.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord.
Pulling the cord can damage the power cord. Use of damaged power cords could result in fire
or electric shock.
• Before installing or removing options, always disconnect the power cord plugs from the wall
outlet and allow time for the main unit to fully cool. Failing to take these precautions could result
in burns.
• Wait at least one hour after power off before replacing parts. Not allowing the machine to
cool may result in burns.
• Before beginning work, ground yourself by touching something metal to discharge any static
electricity. Static electricity can damage the interface board.
• Do not subject the board to physical shocks.
Installing the Gigabit Ethernet Board
(mainly Europe and Asia)
This section describes how to install the Gigabit Ethernet board.
• The machine's Ethernet and USB ports are not available when the Gigabit Ethernet board is
installed into the machine. Use the Ethernet and USB ports on the Gigabit Ethernet board.
4. Installing Options
108
To Next Page
Loading...
