2. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
3. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4. Turn on the main power switch of the machine.
1. Indicators
When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the
machine is not connected to the network, both LEDs are turned off.
• For details about how to turn on the main power switch, see “Turning On/Off the Power”.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
• page 74 "Turning On/Off the Power"
Connecting to the USB (Type B) Interface
This section describes how to connect the USB2.0 (Type B) interface cable to the USB2.0 port.
Connecting the Machine
91
To Next Page
Loading...
