Inserting and Removing a Removable Memory
Device
This section discusses how to insert/remove a removable memory device.
• Do not turn off the main power switch while the machine is saving data to a removable memory
device. Doing so may damage the device. If you turned off the main power switch while data was
being saved, be sure to check whether the data in your device was saved correctly.
• This machine supports SD cards with a maximum capacity of 2 GB.
• If the media access lamp does not light when a removable memory device is pushed into the media
slot, do the following:
• Reinsert the removable memory device.
• The removable memory device may be broken. Contact the shop where you bought it.
Inserting an SD Card
This section describes how to insert an SD card.
1. Align the SD card in the correct direction, and then push it straight into the media slot until
it clicks.
When it is inserted correctly, the media access lamp beside the media slot lights.
• The media access lamp lights up only when the SD card is being accessed.
Inserting and Removing a Removable Memory Device
95
To Next Page
Loading...
