• When the "Replace Print Cartridge." message appears
• When the print cartridge is being replaced
• When the User Tools screen is displayed
• When fixed warm-up is in progress
• When data is being processed
• When operations are suspended during printing
• When the On-hook dialing function is in use
• When a recipient is being registered in the address list or group dial list
• When the Data In indicator is on or blinking
• When the screen of a document that was stored under the printer function appears. (The
machine enters Energy Saver mode if this happens.)
• When the sample print, locked print, hold print, or stored print screen is displayed
• When the internal cooling fan is active
Loading Paper into Tray 1
This section describes how to load paper into tray 1.
• When loading paper, take care not to trap or injure your fingers.
• Do not stack paper over the limit mark.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
1. Lift and pull tray 1 carefully, and then pull it out with both hands.
Place the tray on a flat surface.
3. Getting Started
80
To Next Page
Loading...
