• If paper feed units (optional) are attached, remove them from the machine and move them
separately.
• page 74 "Turning On/Off the Power"
Moving the Machine
This section describes precautions when moving the machine.
1. Be sure to check the following points:
• The power switch is turned off.
• The power cord is unplugged from the wall outlet.
• The interface cable is unplugged from the machine.
2. If any external options are attached, remove them.
See the relevant sections in this manual and reverse the steps to remove options.
3. Lift the machine by the inset grips on its sides.
At least four people are needed to lift the machine.
4. Move the machine horizontally to the place where you want to install it.
5. If you removed options, reattach them.
For details, see the relevant sections in this manual.
• Be sure to move the machine horizontally. To prevent toner from scattering, move the machine
slowly.
9. Remarks
170
To Next Page
Loading...
