Environments to avoid
This section describes environments to avoid when locating the machine.
• Locations exposed to direct sunlight or other sources of strong light (more than 1,500 lux).
• Locations directly exposed to cool air from an air conditioner or heated air from a heater. (Sudden
temperature changes can cause condensation to form inside the machine.)
• Locations close to machines generating ammonia, such as a diazo copy machine.
• Places where the machine will be subject to frequent strong vibration.
• Dusty areas.
• Areas with corrosive gases.
Access to the machine
This section describes the space required for the machine.
Place the machine near the power source, providing the clearance areas shown.
1. Left: 10 cm (4.0 inches) or more
2. Front: 35 cm (13.8 inches) or more
3. Above: 35 cm (13.8 inches) or more
4. Rear: 30 cm (11.9 inches) or more
5. Right: 10 cm (4.0 inches) or more
• For the required space when options are installed, contact your service representative.
Power Connection
This section describes power supply.
Installing the Machine
67
To Next Page
Loading...
