5. Adding Paper
This chapter describes recommended paper sizes and types, and how to load paper into the paper tray.
Loading Paper
This section describes how to load paper into the paper tray.
• When loading paper, take care not to trap or injure your fingers.
• Do not stack paper over the limit mark.
• Straighten curled or warped paper before loading.
• For details about paper sizes and types, see “Recommended Paper Sizes and Types”.
• To load paper in the bypass tray, see “Copying from the Bypass Tray”, Copy and Document
Server Reference.
• page 136 "Recommended Paper Sizes and Types"
Loading Paper into Trays 1 - 4
This section describes how to load paper into trays 1 4.
Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded in tray 1.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• During copying or printing, do not open or close the covers or bypass tray, or pull out or push in
the paper tray.
121
To Next Page
Loading...
