Ricoh Aficio SP 5200S - Connecting to the Ethernet Interface (Mainly North America)

4. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
5. Turn on the main power switch of the machine.
CFL014
1
1. Indicators
When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the
machine is not connected to the network, both LEDs are turned off.
• For details about how to turn on the main power switch, see “Turning On/Off the Power”.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
• page 74 "Turning On/Off the Power"
Connecting to the Ethernet Interface
(mainly North America)
This section describes how to connect an Ethernet cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1. Make sure the main power is switched off.
3. Getting Started
90