• If the board was not installed properly, repeat the procedure from step 3. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• Before using the wireless LAN interface board, you must configure settings. For details, see
“Interface Settings”, Network and System Settings Reference.
Installing the File Format Converter
This section describes how to install the file format converter.
1. Check the contents of the package.
2. Turn off the main power switch, and then unplug the machine's power cord from the wall
outlet.
3. Loosen two screws and remove the cover of the slot in which the file format converter is
installed.
4. Installing Options
116
To Next Page
Loading...
