• When accessing User Tools
• During interrupt copying
• During On-hook dialing for fax transmission
• While scanning an original
• The copy display is set as the default screen when the machine is turned on. You can change this
default setting under Function Priority. See “System Settings”, Network and System Settings
Reference.
System Reset
This section explains System Reset.
After finishing a job, the machine waits a specified length of time and then restores its settings to the
default values specified under Function Priority. This function is called “System Reset”. For the procedure
for specifying default settings under Function Priority, see “System Settings”, Network and System
Settings Reference.
To change the length of time that the machine waits before restoring its settings to their default values,
use the System Auto Reset Timer setting. See “System Settings”, Network and System Settings Reference.
Multi-Accessing
If you are not able to carry out your job, it may be that the machine is being used by another function.
Wait until the current job is completed before trying again. In certain cases, you can carry out another
job using a different function while the current job is being performed. Performing multiple functions
simultaneously like this is called “Multi-accessing”.
Combination Chart
The chart shows function compatibility when print priority is set to [Interleave]. For details about
Print Priority, see “General Features”, Network and System Settings Reference.
: Simultaneous operations are possible.
: Operation is enabled when the relevant function key is pressed and remote switching (of the
scanner/external extension) is done.
: Operation is enabled when the [Interrupt] key is pressed to interrupt the preceding operation.
: Operation is performed automatically once the preceding operation ends.
: The operation must be started once the preceding operation ends. (Simultaneous operations
are not possible.)
3. Getting Started
84
To Next Page
Loading...
