• Be sure to disconnect the plug from the wall outlet and clean the prongs and the area around
the prongs at least once a year. Allowing dust to build up on the plug constitutes a fire hazard.
• When performing maintenance on the machine, always disconnect the power cord from the
wall outlet.
• Power Source
• (mainly Europe and Asia)
220 240 V, 50/60 Hz, 7 A
• (mainly North America)
120 127 V, 60 Hz, 12 A
Please be sure to connect the power cord to a power source as above.
• Voltage tolerance
• (mainly Europe and Asia)
Voltage must not fluctuate by more than 10%.
•
(mainly North America)
Voltage must not fluctuate by more than +8.66% or less than -10%.
Unpacking
To protect it from shock and vibration during transit, this machine comes packaged in cushioning foam
and secured with tape. Remove these protective materials after bringing the machine to where it will be
installed.
• Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies
and small children at all times. Suffocation can result if polythene materials are brought into
contact with the mouth or nose.
• Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside
this machine are high voltage components that are an electric shock hazard and laser
components that could cause blindness. Contact your sales or service representative if any of the
machine's internal components require maintenance, adjustment, or repair.
• Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
Note again that exposure to the laser components inside this machine risks blindness.
Installing the Machine
69
To Next Page
Loading...
Need help?
General
