• Wait at least one hour after power off before replacing parts. Not allowing the machine to
cool may result in burns.
• Type 1 weighs approximately 45 kg (99.2 lb.), type 2 weighs approximately 47 kg (103.7
lb.), and type 3 weighs approximately 52 kg (114.7 lb.). When moving the machine, use the
inset grips on both sides, and lift slowly. The machine will break or cause injury if dropped.
• When moving the machine after use, do not take out the print cartridge to prevent toner spill
inside the machine.
• Do not connect the Ethernet port of the machine to a network that may supply excess voltage,
such as a telephone line. Doing so may result in fire or electric shock.
Handling the machine's interior
This section explains safety precautions about handling the machine's interior.
• Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside
this machine are high voltage components that are an electric shock hazard and laser
components that could cause blindness. Contact your sales or service representative if any of the
machine's internal components require maintenance, adjustment, or repair.
• Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
Note again that exposure to the laser components inside this machine risks blindness.
• Be sure to turn off the power switch and wait for about 15 minutes before cleaning the
registration roller. Not waiting for the machine to cool down can result in a burn.
• Some of this machine's internal components get very hot. For this reason, take care when
removing misfed paper. Not doing so could result in burns.
• The inside of the machine could be very hot. Do not touch the parts with a label indicating the
“hot surface”. Otherwise, an injury might occur.
• When loading paper, take care not to trap or injure your fingers.
• During operation, rollers for transporting the paper and originals revolve. A safety device has
been installed so that the machine can be operated safely. But take care not to touch the
machine during operation. Otherwise, an injury might occur.
28
To Next Page
Loading...
