EasyManua.ls Logo

Ricoh B264 - Page 771

Ricoh B264
918 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ERROR CODES
SM 19 B779
Fax Option
B779
Code Meaning Suggested Cause/Action
15-39
Send/Delivery Destination
Error
The transmission cannot be delivered to the final
destination:
Destination file format is incorrect.
Could not create the destination for the file
transmission.
15-41 SMTP Receive Error
Reception rejected because the transaction
exceeded the limit for the “Auth. E-mail RX” setting.
15-42 Off Ramp Gateway Error
The delivery destination address was specified with
Off Ramp Gateway OFF.
15-43 Address Format Error
Format error in the address of the Off Ramp
Gateway.
15-44 Addresses Over
The number of addresses for the Off Ramp
Gateway exceeded the limit of 30.
15-61
Attachment File Format
Error
The attached file is not TIFF format.
15-62 TIFF File Compatibility Error Could not receive transmission due to:
Resolution error
Image of resolution greater than 200 dpi without
extended memory.
Resolution is not supported.
Page size error
The page size was larger than A3.
Compression error
File was compressed with other than MH, MR, or
MMR.
15-63 TIFF Parameter Error
The TIFF file sent as the attachment could not be
received because the TIFF header is incorrect:
The TIFF file attachment is a type not supported.
The TIFF file attachment is corrupted.
Software error.
15-64 TIFF Decompression Error
The file received as an attachment caused the TIFF
decompression error:
The TIFF format of the attachment is corrupted.
Software error.
15-71 Not Binary Image Data
The file could not be received because the
attachment was not binary image data.
15-73 MDN Status Error
Could not find the Disposition line in the header of
the Return Receipt, or there is a problem with the
firmware.
15-74 MSDN Message ID Error
Could not find the Original Message ID line in the
header of the Return Receipt, or there is a problem
with the firmware.
15-80 Mail Job Task Read Error
Could not receive the transmission because the
destination buffer is full and the destination could
not be created (this error may occur when receiving
a transfer request or a request for notification of
reception).

Table of Contents

Related product manuals