Ricoh B264 - Page 772

ERROR CODES
B779 20 SM
Code Meaning Suggested Cause/Action
15-81
Repeated Destination
Registration Error
Could not repeat receive the transmission because
the destination buffer is full and the destination
could not be created (this error may occur when
receiving a transfer request or a request for
notification of reception).
15-91 Send Registration Error
Could not receive the file for transfer to the final
destination:
• The format of the final destination or the transfer
destination is incorrect.
• Destinations are full so the final and transfer
destinations could not be created.
15-92 Memory Overflow
Transmission could not be received because
memory overflowed during the transaction.
15-93 Memory Access Error
Transaction could not complete due to a malfunction
of SAF memory.
15-94 Incorrect ID Code
The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
15-95 Transfer Station Function
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
22-00
Original length exceeded the
maximum scan length
Divide the original into more than one page.
Check the resolution used for scanning. Lower the
scan resolution if possible.
Add optional page memory.
22-01
Memory overflow while
receiving
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an another
fax machine, if the machine’s printer is busy or out
of order.
Add an optional SAF memory card or hard disk.
22-02
Tx or rx job stalled due to
line disconnection at the
other end
The job started normally but did not finish normally;
data may or may not have been received fully.
Restart the machine.
22-04
The machine cannot store
received data in the SAF
• Update the ROM
• Replace the FCU.
22-05
No G3 parameter
confirmation answer
• Defective FCU board or firmware.
23-00
Data read timeout during
construction
Restart the machine.
Replace the FCU
25-00
The machine software
resets itself after a fatal
transmission error occurred
• Update the ROM
• Replace the FCU.
F0-xx V.34 modem error Replace the FCU.
F6-xx SG3-V34 modem error Update the SG3-V34 modem ROM.
Replace the SG3-V34 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.