Ricoh B264 - Page 784

SERVICE PROGRAM MODE
B779 32 SM
G4 Parameter Switch
109
001 – 016 00 – 0F Not used (Do not change the bit switches)
IP fax Switch 111
001 – 016 00 – 0F
Change the bit switches for optional IP fax
parameters
 Section 3.2 Bit Switches
SP2-XXX (RAM Data)
2
Mode No. Function
RAM Read/Write 101
001
Change RAM data for the fax board directly.
 Section 3.5 Service RAM Addresses
Memory Dump 102
001 G3-1 Memory Dump
Print out RAM data for the fax board.
 Section 3.5 Service RAM Addresses
002 G3-2 Memory Dump
Print out RAM data for the optional SG3
board.
003 G3-3 Memory Dump
Print out RAM data for the optional SG3
board.
102
004 G4 Memory Dump Print out RAM data for the SiG4 board.
G3-1 NCU Parameters 103
001 – 023 CC, 01 – 22
NCU parameter settings for the standard
G3 board.  Section 3.3 NCU Parameters
G3-2 NCU Parameters 104
001 – 023 CC, 01 – 22
NCU parameter settings for the optional G3
board.  Section 3.3 NCU Parameters
G3-3 NCU Parameters 105
001 – 023 CC, 01 – 22
NCU parameter settings for the optional G3
board.  Section 3.3 NCU Parameters
SP3-XXX (Tel Line Settings)
3
Mode No. Function
Service Station
001 Fax Number Enter the fax number of the service station.
101
002 Select Line Select the line type.
Serial Number 102
000 Enter the fax unit’s serial number.
PSTN-1 Port Settings
001 Select Line
Select the line type setting for the G3-1 line.
If the machine is installed on a PABX line,
select “PABX”, “PABX(GND)” or
“PABX(FLASH)”.
103
002 PSTN Access Number
Enter the PSTN access number for the
G3-1 line.