BIT SWITCHES
B779 44 SM
System Switch 12 SP No. 1-101-019
No FUNCTION COMMENTS
0
to
7
TTI printing position in the main
scan direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI from the left edge of the paper. If the TTI is
moved too far to the right, it may overwrite the file
number which is on the top right of the page. On an
A4 page, if the TTI is moved over by more than 50
mm, it may overwrite the page number.
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 SP No. 1-101-022
No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2-3 Not used Do not change these settings.
4-5
Interval for preventing the
machine from entering Energy
Saver mode if there is a
pending transmission file.
Bit 5 4 Setting
0 0 1 min
0 1 30 min
1 0 1 hour
1 1 24 hours
If there is a file waiting for transmission, the machine
does not go to Energy Saver mode during the
selected period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver
mode.
6-7 Not used Do not change
To Next Page
Loading...
