Ricoh D127 - Adjusting Blank Margin

SP Specification
SP1-001-001 (All Trays) 0 ± 2 mm
SP1-001-002 (By-pass) 0 ± 2 mm
SP1-001-003 (Duplex) 0 ± 4 mm
5. Adjust the leading edge registration (SP1-001).
6.
Measure the distance between the side edge of the image area and the side edge of the paper [B].
SP Specification
SP1-002-001 (1st tray) 0 ± 2 mm
SP1-002-002 (2nd tray) 0 ± 2 mm
SP1-002-003 (3rd tray) 0 ± 2 mm
SP1-002-004 (By-pass) 0 ± 4 mm
SP1-002-005 (Duplex) 0 ± 4 mm
7. Adjust the side-to-side registration (SP1-002).
8.
Select "Cancel" in SP2-109-001 after finishing the adjustment procedure.
Adjusting Blank Margin
Use the Trimming Area Pattern (SP2-109-001 > 10) for this adjustment.
1. Print out the test pattern.
2. Measure the distance between the four edges of the image area and the four edges of the paper
[A][B][C][D].
Adjusting Copy Image Area
135