2995 3
JobEnd / Interrupt -
Sets the condition at which ID sensor control takes place.
2996* Transfer Roller Cleaning [0 = No / 1 = Yes]
2996 1
Cleans or does not clean the transfer roller before each job. Select “1” if the backside of
the paper becomes unclean when output. Note that the copier takes a longer time to
output the first copy when you select “1”. If you select “0”, the transfer roller is never
cleaned.
2996 2
Interval [0 to 100 / 50 / 1 /step]
When the “SP2-996-003” counter is over this SP’s value, Transfer roller cleaning is
activated on the Job-End timing. If this SP’s value is 0, cleaning doesn’t act.
2996 3
Counter [0 to 255 / 0 / 1 /step]
The counter Applying to “SP2996-002” (Interval).
2998* PCU Reverse Rotation Time
2998 1 Wait Time [0 to 999 / 300 / 1 /step= 30ms]
2998 2 Reverse Time [0 to 99 / 60 / 1 /step= 6ms]
2998 3
Brake Time [0 to 99 / 0 / 1 /step= 3ms]
DO NOT use this SP in usual operations.
SP4-XXX (Scanner)
4008* SubScan Mag Adjustment [-1.0 to +1.0 / 0.0 / 0.1 %/step]
4008 1
Adjusts the sub-scan magnification ( "Adjusting Copy Image Area" in the section
"Replacement and Adjustment").
4010* L – Edge Regist Adjustment [–1.0 to +1.0 / 0.0 / 0.1 mm/step]
4010 1
Adjusts the leading edge registration ( "Adjusting Copy Image Area" in the section
"Replacement and Adjustment").
4011* S-to-S Regist Adjustment [–2.0 to +2.0 / 0.0 / 0.1 mm/step]
3. Appendix: SP Mode Tables
40
To Next Page
Loading...
