Ricoh D127 - Input Check (SP5-803); Conducting Input Check; Input Check Table

9968
Soft Start: Wait
Soft start parameter on wait time
001 First duty [0 to 100 / 15 / 0.01 %/step ]
002 Duty step [0 to 100 / 5 / 0.01 %/step ]
003 Last duty [0 to 100 / 50 / 0.01 %/step ]
004 Repeat count [0 to 255 / 4 / 1/step ]
9969
Soft Stop: Wait
Soft stop parameter on wait time
001 First duty [0 to 100 / 60 / 0.01 %/step ]
002 Duty step [0 to 100 / 10 / 0.01 %/step ]
003 Last duty [0 to 100 / 30 / 0.01 %/step ]
004 Repeat count [0 to 255 / 2 / 1/step ]
Input Check (SP5-803)
Conducting Input Check
1. Select SP5-803.
2.
Select the number (see the table below) corresponding to the component.
3. Select "Start" The copy mode is activated.
4. The sign "01H" or "00H" is displayed (see the table below).
Input Check Table
Num. Sensor/Switch 1h (00000001) 0h (00000000)
009 Tray 1: Paper End Sensor Paper detected Not detected
016 By-pass: Paper End Sensor Paper detected Not detected
019 Paper Exit Sensor Paper detected Not detected
System Service Mode
145