Ricoh D127 - Scanner HP Sensor

1. Push the spring [A] located on the opposite side of the scanner motor [B] to loosen the belt [C] from
the scanner motor gear.
2.
Remove the screws on the top of the scanner motor [B] (
x 4).
3.
Turn the scanner motor [B] back. Then remove the screws and the harness on the back (
x 2
x1).
Scanner HP Sensor
1. Rear cover ( p.78 "Rear Cover")
2.
Scanner Cover and Exposure Glass (
Scanner Cover and Exposure Glass)
3.
Two of the brackets [A] [B] and the rail [C] (
x 6)
4.
Scanner HP sensor [D] (
x 1, x 1)
Scanner Unit
85