Installation Procedure
1. Rear cover ( x 5)
2. Attach the Fax Unit [A] to the bracket [B] with placing the sheet [C] between the unit [A] and the
bracket [B]. ( x 4)
3. Attach the Bracket Guide [D] as shown.
4. Slot the bracket assembled in procedure 2 in between two of the guides as the blue arrow shows.
5. Attach the large end of the Harness with the Band [E] and connect the small end to on the Fax Unit [A]
as the red arrows shows.
6. Attach the Speaker [F] and its connector to the large end of the Harness [E].
7. Attach the ferrite core [A] on the speaker harness within 50mm from the end of the controller board.
This prevents the harness from being involved in the fan [B].
Controller Options
65
To Next Page
Loading...
