Ricoh D127 - Hot Roller and Fusing Lamp

1. Fusing unit ( p.86 "Fusing Unit")
2.
Separate the fusing unit into two sections: the hot roller section [A] and the pressure roller section
[B] (
x 2).
After removing the screws, lower the pressure roller section about halfway and then slide it toward
the front side to detach it.
3.
Support rollers [C]
4. Hot roller stripper pawls [D]
• Remove the spacer [E] ( x 1) if you are removing the hot roller assembly ( p.88 "Hot
Roller and Fusing Lamp").
Hot Roller and Fusing Lamp
• Do not touch the fusing lamp and rollers with your bare hands.
4. Replacement and Adjustment
88