• When reinstall the PCU, be sure to hook the PCU connector cable as shown above so as not to
damage the cable.
5. When having installed a new PCU, remove the Styrofoam and tags ( p.31 "Copier" in the chapter
"Installation").
Initialization
After replacement, Do “SP2801-001” to initialize the copier setting for PCU.
Quenching Lamp
1. PCU ( p.93 "PCU")
2.
Remove the Lamp Shading [A] (Adhered)
3. Put the Quenching lamp [B] out as the blue arrow shows on pushing carefully as the red arrow
shows. (
x 1)
4. Replacement and Adjustment
94
To Next Page
Loading...
