Ricoh D127 - Interface Settings; Copier Settings

21. Attach the ferrite core [O] to the end of the network cable [P] when connecting the cable.
22. Attach the ferrite core to the telephone line in the same manner as step 21.
23. Connect the telephone line to the "LINE" jack.
• The end of the ferrite core must be about 9 cm (3.6") from the end of the cable. (EU, AP, CHN)
24. Plug in the machine and turn on the main power switch [Q].
25. Select the language used in the operation panel as necessary ( > Language).
Interface settings
1. Start the SP mode.
2.
Select SP5-985-001 (NIC setting) and change the setting value to "1" (ON).
3. Select SP5-985-002 (USB setting) and change the setting value to "1" (ON).
4. Turn the main switch off and on.
Copier settings
1. Start the SP mode.
2.
Select SP5-801-001 and execute the initialization.
3. Exit the SP mode, and then start the UP mode.
4. Select the "@Remote Service" ("User Tool" > "System Settings > Administrator Tools" > "Extended
Security" > @Remote Service") and select "Do not Prohibit".
5. Exit the UP mode, and then start the SP mode.
Copier
35