1110 2 Media Print Device Setting [0: Disabled 1: Enabled]
Sets I/F (USB/SD device) Enabled/Disabled on the
media print function.
SP Modes Related to Printer Controller
The following SP modes are located in the system SP mode. Refer to section 5.1 of the main unit service
manual.
SP No. Description Function and Setting
5801
-001
Memory All Clear
Resets data for process control and all software counters, and
returns all modes and adjustments to their defaults values.
Section "Memory Clear" in this chapter for details.
5907
Plug & Play Maker/
Model Name
Selects the brand name and the production name for Windows
Plug & Play. This information is stored in NVRAM.
7832
Self-Diagnose Result
Display
Displays the controller self-diagnostic result.
Scanner Program Mode Table (Scanner SP Tables)
Service Table Key
Notation What it means
[range / default /
step]
Example: [-9 to +9 / +3.0 / 0.1 mm step]. The setting can be adjusted in the
range ±9, value reset to +3.0 after an NVRAM reset, and the value can be
changed in 0.1 mm steps with each key press.
italics Comments added for your reference.
* This value is stored in NVRAM. After a RAM reset, the default value (factory
setting) is restored.
DFU Denotes "Design or Factory Use". Do not change this value.
3. Appendix: SP Mode Tables
154
To Next Page
Loading...
